mighty mouse high density www.glenair.com e-mail: sales@glenair.com glenair, inc. ? 1211 air way ? glendale, ca 91201-2497 ? 818-247-6000 ? fax 818-500-9912 29 dimensions in inches (millimeters) are subject to change without notice. ? 2011 glenair, inc. u.s. cage code 06324 printed in u.s.a. g lenair band-master? advanced termination system: how to order fast, cost-efective shield termination. attach cable shields to backshells with band-master? ats stainless steel straps. the band-master? ats system ofers fast termination and the fexibility to handle a wide range of parts with just one band size. approved for aerospace and defense, these straps have successfully passed rigorous shock, vibration and environmental testing. 1 band installation tool. use with .240" (6.10 mm) wide bands. 6.75 inches (172 mm) length, 1.2 pounds (0.6 kg.) 1 2 standard band, .240" (6.10 mm) wide. available in two lengths, fat or pre-coiled. stainless steel. 2 figure description part number 1 band installation tool 600-058 figure length part number accommodates diameter in. mm flat pre-coiled in. mm 2 14.250 362.1 600-052 600-052-1 1.8 45.7 2 18.000 457.2 600-090 600-090-1 2.5 63.5 contact glenair or visit our website (glenair.com) to view our complete line of band-master? ats products, including pneumatic tools for high volume production and calibration kits. 1. prepare cable braid for termination process (figure 1). 2. push braid forward over adapter retention lip to the adapter incline point (or .4" [10.2mm] minimum braid length). milk braid as required to remove slack and insure a snug ft around the shield termination area (figure 2). 3. prepare the band in the following manner: important: due to connector/adapter cir - cumference, it may be necessary to prepare the band around the cable or retention area. a. roll band through the buckle slot twice. (bands must be double-coiled.) b. pull on band until mark ( ) is within ap - proximately .250 inch (6.4mm) of buckle slot (figure 3). the band may be tightened further if desired. note: prepared band should have ( ) mark visible approximately where shown in figure 3. shield termination clamping process (figures 4 thru 8) note: to free tool handles, move holding clips to center of tool. 4. squeeze gripper release lever and insert band into the front end opening of the tool. (note: circular portion of looped band must always face downward.) 5. aligning the band and tool with the shield termination area, squeeze black pull-up handle repeatedly using short strokes until it locks against tool body. (this indicates the band is compressed to the tool preca - librated tension.) note: if alignment of band and shield is unsatisfactory, tension on band can be relaxed by pushing on slotted release lever on top of tool. make adjustments as necessary and again squeeze black pull-up handle. 6. complete the clamping process by squeez - ing the gray cut-of handle. 7. remove excess band from tool and dispose. 8. inspect shield termination. band-master? ats shield termination instructions 1 3 5 7 buckle tail length indicator mark adapter retention lip conductors braid adapter incline 2 4 6 8 .400 (1.2mm) min. length braid over termination area ta il length indica t or mark series 811 mighty mouse high density (hd) contacts and tools b and-master? advanced termination system bands and instructions .240 (6.10) .350 (8.9) length .060 (1.5) indica or mark
|
